MIL-STD-35-108A(MI)
21 MAY 1993
FOREWARD
1. This Military Standard is approved for use by all Departments
and Agencies of the Department of Defense.
2. Beneficial comments (recommendations, additions, deletions)
and any pertinent data which may be of use in improving this
document should be addressed to Commander, U.S. Army Missile
Research and Development Command, ATTN: AMSMI-RD-SE-TD, Redstone
Arsenal, Alabama 35809, by using the Standardization Document
Improvement Proposal (DD Form 1426) appearing at the end of this
document or by letter.
3. The purpose of MIL-STD-35-108A(M1) is to provide instructions
for the preparation of Specification Requirements Sheets (SRS) in
order to produce Military Specification Exceptions for
Transmitters.
4.
In order to properly utilize this document, it is necessary
to have a complete and thorough understanding of the MIL-STD-35.
5. It is important that the procedures described in the basic
document (MIL-STD-35 and subsequent revisions) be followed
explicitly in order to produce a document suitable for
procurement.
Information which is standard for all dash-numbered
parts has been included in the basic document at the issuance of
MIL-STD-35.
This information is not repeated in each
dash-numbered part.
ii
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business