DOD-STD-35-71A(MI)
14 January 1983
4. GENERAL REQUIREMENTS
In order to properly prepare a SRS for a thermal switch,
4.1 Introduction.
it is necessary to use DOD-STD-35 in conjunction with this dash-numbered part.
In the event the instructions or the writing methodology are not followed,
an AEDPS edit routine will print error messages rather than the desired
MSE document.
4.2 Specification Requirement Sheet (SRS). SRS requirements described in
DOD-STD-35 are applicable to Switches, Thermal.
4.3 Configuration.
4.3.1 Dimensions. SRS requirements for dimensions described in DOD-STD-35
are applicable to Switches, Thermal.
Illustrations applicable to Switches, Thermal are
4.3.2 Illustrations.
contained in Appendix A to this document.
4.4 Units of measure. The International System of Units (SI) or inch-
pound units (U.S.), may be used to specify characteristics (e.g. weight,
dimensions). Refer to ASTME380 for guidance in using SI. However, when
different units of measure are available for specifying a characteristic,
only one may be used. Both units of measure cannot appear in the same
MSE.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business