DOD-STD-35-36B(MI)
20 February 1979
4. GENERAL REQUIREMENTS
4.1 Introduction. In order to properly prepare an SRS for Seals, Gaskets,
and Packing, it is necessary to use DOD-STD-35 in conjunction with this dash-
numbered part. In the event the instructions or the writing methodology are
not followed, an AEDPS edit routine will print error messages rather than
the desired MSE document.
4.2 Specification Requirement Sheet (SRS). SRS requirements described in
DOD-STD-35 are applicable to Seals, Gaskets, and packing
4.3 Configuration.
4.3.1 Dimensions. SRS requirements for dimensions described in DOD-STD-35
are applicable to Seals, Gaskets, and Packing.
4.3.2 Illustrations. Illustrations applicable to Seals, Gaskets, and
Packing are contained in Appendix A to this document.
4.4 Units of measure. The International System of Units (SI) or inch-
pound units (U.S.), may be used to specify characteristics (e.g. weight,
dimensions). Refer to ASTME380 for guidance in using SI. However, when
different units of measure are available for specifying a characteristic,
only one may be used. Both units of measure cannot appear in the same
-
MSE.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business