DOD-STD-35-1OOA(MI)
12 August 1978
4. GENERAL REQUIREMENTS
In order to properly prepare an SRS for Regulators and
4.1 Introduction.
Nonpowered Valves (Hydraulic, Pneumatic, and Vacuum), it is necessary to use
DOD-STD-35 in conjunction with this dash-numbered part. In the event the
instructions or the writing methodology are not followed, an AEDPS edit
routine will print error messages rather than the desired MSE document.
4.2 Specification Requirement Sheet (SRS). SRS requirements described in
DOD-STD-35 are applicable to Regulators and Nonpowered Valves (Hydraulic,
Pneumatic, and Vacuum).
4.3 Configuration.
4.3.1 Dimensions. SRS requirements for dimensions described in DOD-STD-35
are applicab le to Regulators and Nonpowered Valves (Hydraulic, Pneumatic,
and Vacuum).
4.3.2 Illustrations. Illustrations applicable to Regulators and Nonpowered
Valves Hydraulic, Pneumatic, and Vacuum) are contained in Appendix A to this
document.
4.4 Units of Measure. The International System of Units (SI) or inch-
pound units (U.S.) may be used to specify characteristics (e.g. weight,
Refer to ASTME380 for guidance in using SI. However, when
dimensions).
different units of measure are available for specifying a characteristic,
only one may be used. Both units of measure cannot appear in the same MSE.
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business